REMIX of DM Screen (Magnet Joins)
Description
This is a remix of https://www.thingiverse.com/thing:3255820 The original file provided was too large to print on a bed. I split the pieces into individual files. All credit for this goes to https://www.thingiverse.com/Berko ----------------------- This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/fKuiL4wmnpz This has been printed and tested!!! To join it, you will need 6mm X 1.5mm Magnets (can buy off ebay cheap!) each panel has six magnets - if you do it properly, all the panels should join in any order! be careful when you glue them, its hard to remove them without wrecking the panels!!! The Main Panel = 180mm X 158.17mm X 8mm The Wall Panel = 180mm X 141.9 mm X 8mm Corner Joins = 180mm X 19.75mm X 18.67mm The Main Panels can be printed with 10% infill, Make sure you have 5-6 top layers and the fan on to combat the infill. have only printed in PLA The Corner Joins - print with the panel between the magnet holes facing up! saves wasting plastic on supports. - best to have your fan on to help print!
Statistics
Likes
10
Downloads
0