Prusa Spool holder Table stand
Description
This is a squashed Bug to use your one-piece Prusa spool holder as a Table Spool holder. I had a dual spool holder with my Mk3 so I could justify making this over seperate spool holders. My settings with PLA: Layer 0.2 mm 60% infill cubic Support on -needed around 180 gramm of PLA with these settings. Edit: My spool holder had a 30mm wide clip on area. Printed versions from Prusa have a 35mm wide area. I enlarged my model a little to make them work as well. Clip on area on the model is now 36mm wide, 40mm high and 6mm deep.
Statistics
Likes
4
Downloads
0