Nintendo Switch Handles
Description
I created this because I didn't love any of the existing designs. One has seams, screw holes, and etc. that I didn't care for. Another two piece would allow the actual switch unit to fall out the bottom of the grips if you weren't careful. So I designed this that basically combined ideas from each design that I did like. This will fit on a 250 mm print bed if it is turned to the diagonal. After confirming the original print was what I wanted and everything fit correctly, I split the model in 2 for smaller print beds. I haven't tested the 2 piece print but it should have enough tolerance on a well tuned printer so that the pieces have a snug fit (but not too tight or too loose). If anyone does do that 2 piece print let me know if anything needs changed. For the two piece print I would orient the pieces as shown in the 4th (green) image with supports and at least a 5mm brim.
Statistics
Likes
33
Downloads
0