Go Pro Session protection + filter 52mm
Description
This was initially a weekend project that went for a few days extra. I always wanted to add FILTERS to my Go Pro Session but without cutting any glass or destroying filters that i already had lying around the house. So i took the smallest that i had at hand: 52mm and tried to adapt it to the Go Pro. For the moment i have printed only in PLA although my initial plan was meant for some TPU...i will come back with some photos when i will do it. I printed the parts using supports but this option will be up to you and your printer... If you have anything to add or any crazy idea please don't hesitate to comment :) The version without the two tabs can be used on some Drone Frames. It will fit perfect on a Diatone Crusader frame for example. Camera goes in through the back and fits pretty snug but for those who do not like that there is also a lid that goes at the end and encloses the camera within the protection ... there is also a small ridge close to the top where the filters are. That is intended to stop the camera from sliding into the filter and destroying it from behind. depending on the printer you might need to deburr the holes and especially the little ridge that is meant to stop the camera from sliding....i discovered that sometimes it needs a bit of attention but that depends on the printing material, printer and many others factors...
Statistics
Likes
41
Downloads
0