Node 202 more 2.5" drives Mod
Description
Warnings: -The following guide doesn't guarantee success, if something goes wrong you are on your own. -Some cable management / ziptie mounts might need to be flattened -I haven't tuned the design yet This mod requires: -Sfx (non sfx-L and possibly non modular)power supply -m3/m4 Drill bit -Drill -Two m3/m4 1cm long screws (not 11mm) -Two m3/m4 nuts. Possibly useful: -Files to clean up the printed parts Adds support for up to 6 x (2.5" 7mm thick drives), it works with the thicker ones too (15mm), plus as a bonus a 40x40x10 mm fan space (requires additional modding) to keep them cool. Guide: 1)remove the hard drive caddy 2)Mark the 70mm gap between the psu and the internal support bracket with a pencil on the outer frame two straight vertical lines. You can first apply a layer of painter's tape to make it more visible 3)Place the base between the two lines and mark for each hole the center 4)Drill a 3mm wide(1.5mm diameter) hole 5)Almost done, put the base from the inside, add all the drives you want, and secure it with two m3 1cm long screw and nuts in place. If you want to add a fan, you'll have to mod the entire front of the case, and make a path for the fan cable, soo good luck, you are on your own. 4 Months later and still works well
Statistics
Likes
3
Downloads
0