Lizard 95 Vertical RX Antenna Mount
Description
Needed a vertical antenna mount for my Lizard 95 after breaking the onboard RX and piggbacking an R-XSR. Mount is designed to be used with antenna/plastic tubes with a 3mm outer-diameter, and slips over the existing standoff between the two side plates for compatibility/ease of use. Files for both single and double antenna mounts included. May require some cleanup work after printing, I used a 4.8mm bit (5mm would probably work) to drill out the standoff hole, and a 3mm bit for the antenna tube holes - just to ensure accurate sizing. Printed without supports with 1.75mm PETG 0.2mm layer height, 100% infill (thing is tiny) 245°C Extruder 90°C Bed
Statistics
Likes
5
Downloads
0