FRC Dual 775 Clamping "Gearbox"
Description
Made by FRC 5254 HYPE. A 775 style motor "gearbox" that clamps onto either 1x1 or 2x1 tubing and allows a reduction using a GT2 Belt. A variety of pulley/belt sizes can be used due to the sliding tension bearing in the middle. There are two versions of the sliding bearing mount depending on the tolerances of your printer. 2" Tubing: follows the spacing of a VEXpro single reduction clamping gearbox. 1" Tubing: follows the spacing of a side bearing gusset Hardware required: 4x 1.25" 8-32 Bolts | [91251A201](https://www.mcmaster.com/91251a201) 4x 8-32 Locknuts | [91831A009](https://www.mcmaster.com/91831a009) 3x 8-32 Heat-set inserts | [93365A140](https://www.mcmaster.com/93365a140) 2x 1/4" ID Bearings | Ex. [6383K213](https://www.mcmaster.com/6383k213) 1x ~1.25 1/4-20 Bolt 1x 1/4-20 Locknut 2x 775 motor | Ex. [775 Pro](https://www.vexrobotics.com/775pro.html) & [Readline](https://www.andymark.com/products/andymark-775-redline-motor) 2x 12T GT2 Pulley | [VEX](https://www.vexrobotics.com/vexpro/motion/belts-and-pulleys/gt2pulleys.html) 1x ??T GT2 Pulley | [VEX](https://www.vexrobotics.com/vexpro/motion/belts-and-pulleys/gt2pulleys.html) or [3D print](https://www.thingiverse.com/thing:3333938) 2x Hex/Thunderhex bearing
Statistics
Likes
101
Downloads
0