Samsung Edge Cradle
Description
Probably dated at this point. A simple cradle for the Samsung Edge. It fits pretty snug, but works great. A little tighter when it's cold. Also, obviously print in PETG or ABS. The first test print I did in PLA worked fine...until summer. The final print in PETG has been solid even in summer. Other parts: Ram Mount (RAM-B-238U) 2.43 x 1.31-Inch Diamond Ball Base with 1-Inch Ball 2 M5 x 0.8mm x 12mm cap screw The screw is just flush on the phone facing side, but be sure to verify it doesn't extend beyond that to make sure it doesn't scratch the phone.
Statistics
Likes
1
Downloads
0