Makerfarm E3D v5 Cooling Fan Duct
Description
This Is A Cooling Duct For The Makerfarm Prusa I# For A E3D V5 Hotend. After Installing The E3D I Starting Getting The Same Warping Issues That I Was Getting With The Magma Hotend And Abs Until In Installed [Papergeek'S Duct](Http://Www.Thingiverse.Com/Thing:161066). I Found [Mikep-Nz'S Duct](Http://Www.Thingiverse.Com/Thing:222873) And Added The Extra Duct Out The Back. I Printed In 2 Halves Then Used [This Method To Weld](Http://Www.Thingiverse.Com/Thing:23606) Them Together I Used A Half Round File To Adjust The Opening For The E3D Heatsink To Slide Into And Ensured It Was A Snug Fit. I Ran Some Silicon Around Where The Fan Sits Against The Duct To Seal It. The Fan Cover From [Papergeek'S Magma Hotend Duct](Http://Www.Thingiverse.Com/Thing:161066) Needs To The Printed At 75% Scale To Fit The 30Mm Fan.
Statistics
Likes
25
Downloads
0