Z Axis Reinforcement and elongation by 30/33mm for Prusa MK2s
Description
****** ATTENTION ********** Note that to fully use this design it require extensive changes : - The x min endstop needs to be moved. - PINDA probe needs to be closer to the extruder - Cables and m3x40 screw must be removed from back of the x carriage ( suggestion to make them go the same route that x axis motor cables. Bottom parts connecting motor to the frame are actually a remix of the Original Parts: https://www.prusa3d.com/prusa-i3-printable-parts/ Does not require any additional changes Hardware or Software @ +0mm with reinforcement : https://www.thingiverse.com/thing:3337357/ Does require small Software change @ + 18mm with reinforcement : https://www.thingiverse.com/thing:3334944/ Does require extensive Software and Hardware changes : @ +30/33mm with reinforcement ---------------------------------- What You need : 2 pcs - 608zz bearing 2 pcs - m8x400mm threaded rod 2 pcs - m8x450mm threaded rod +8 pcs - m8 nut for the above *8 pcs - m8 washer ( note that the outer diameter should not be more than 18mm) 8 pcs - m3x20mm 8 pcs - m3ns nylon lock nut din 985 185g PET-G (21% infill, 2 perimeters) 2 pcs - m4x40mm 2 pcs - m4x20mm 4 pcs - m4 nut
Statistics
Likes
2
Downloads
0