TEENAGE ENGINEERING OP-Z Stand
Description
A stand designed for TEENAGE ENGINEERING OP-Z *not tested yet (Not having the device yet!) but should fit because it's designed based on sizes from a working one *Two circular holes on the bottom are for circular plastic washers to use as stoppers from moving https://www.amazon.com/YunShuo-WASHERS-PLASTIC-WASHER-200PCS/dp/B0792SNZG1 (Something like this but should the check the right size which is 15mm I think) Which will be glued inside the bottom holes *Should print 2 of the file for each side *I used cura for slicing and it's fine but I think the design will have some problems with Simplify if you don't repair it with netfabb first because it was designed in C4D
Statistics
Likes
14
Downloads
0