Ryobi One+ Battery Holder Wall Mount
Description
This is a bracket I made for my stock of ryobi 18v batteries. It is angled to reduce the amount of plastic required to support the depth ofthe battery's extension. V4 should successful 'lock' any "ryobi 18v one" battery using the battery's built in clips. It should (if printed with the tuned settings) be an effortless push-to-lock fit. Much like the battery will do with any ryobi tool, and such release when the battery's clips are depressed. The slots on the back should allow for mounting in either orientation. and were designed for use with #6 flat head screws. This is my first thing; and I know its far from perfect. I made it for my own workshop as a quick and dirty prototype. As such it is Very over engineered and could likely be mounted in a actual workshop and survive a fair bit of abuse without failure. It Should also resist shock, and impact damage from hard insertions or accidental strikes. This also means it should carry any size battery even the 4+ amp hr versions.
Statistics
Likes
268
Downloads
0