Auto Level Sensor Mount - Anet A8 - 8mm Cylinder
Description
My heated bed connector is in the back of my printer, so back sensor mounts tend to hit the connector during print. I therefore created this front/left mount which mounts to the outside of the of the fan. The slots for the barrel were purposefully oversized to ~9mm with slots so no post processing was required. I'll be honest, I assumed the fan screws were 45 degrees from horizontal...They're not. So it has a slight lean to it, but functions very well. Drop a tower of Pisa in with your slicer to get an intentional look. Marlin firmware code for offset: X_PROBE_OFFSET_FROM_EXTRUDER -25 Y_PROBE_OFFSET_FROM_EXTRUDER -40 MIN_PROBE_EDGE 20
Statistics
Likes
3
Downloads
0