Tevo Little Monster Glass Borosilicate Glass Base Clamps
Description
I have Borosilicate glass that I use over the base of my Tevo Little Monster for printing most materials and have a textured surface on the other side of the glass to print materials like PETG. However, the glass clamps I found online were for 16" table glass, which is what I was using previously, and were also not adjustable and not sized for 348mm round sheets of glass that I was switching to. So I set out to design these clamps that would allow me to put tension on the ~3mm thick Borosilicate glass as well as not get in the way of my very low part cooling blower that surrounds my hot end. This way I could also easily release the tension on one piece (of 3 printed) and flip the glass to the textured/sticker side as needed. After a few iterations and tests, I found these to be quick and easy to print and work like a charm. You can print and install more than 3 but at least 3 seem to function optimally.
Statistics
Likes
7
Downloads
0