EMT8 PROTOTYPE PARTS
Description
Note: I sold my Anet A8. I will not be continuing the designs here unless I somehow get another Anet A8 for free (doubtful). I will however leave these up for anyone else that wants to use them or remix them. Good luck. I am working on my EMT8, and I am modifying parts where I see some room for improvement. These are untested designs. I will take this down and make a proper remix once I'm done. I had to print (some of) these parts at 101% to fit my 3/4" EMT. Your results may be different. Just a note on the Y-axis rod mounts: I modified them to have a through hole. So, once they are permanently mounted you can remove the rods without taking any parts of the frame apart. There is a tiny hole in the side of the Y-axis mounts where a wire (like a straight paperclip) is fed through then bent on the outside to lock the rods in place for normal operation. Please ask any questions, or give any constructive criticism you have. Thanks for looking. 5/28/2019: Added 30A power supply mount 8/1/2020: I sold my Anet A8. I will not be continuing the designs here unless I somehow get another Anet A8 for free (doubtful). I will however leave these up for anyone else that wants to use them or remix them. Good luck.
Statistics
Likes
8
Downloads
0