Tap Handle Wall Display
Description
This is a customizable beer tap handle wall display (holder). It is scalable from 2 handles up to an infinite number as large as the wall is. This uses standard 3/8"-16 bolts, 1 inch in length with a low profile nut. The wall mount holes are for a #10 screw. Link for Bolt - https://www.mcmaster.com/catalog/125/3248 Link for Nut - https://www.mcmaster.com/catalog/125/3297 Each section supports 2 tap handles (side sections only support 1 tap handle), there is a middle section along with a left and right to close out the sides. For each section you will need 2 washer cover pieces, along with 1 covers for the wall screws. Purchased hardware would require 2X 3/8"-16 bolts and 2X 3/8" low profile nuts. Each connection will requires 2 pins. All parts print in the orientation in the model. Center section and right hand side will need build support at the ends that have the bridge piece. ****Update Jan/Feb 2020**** Added experimental 125 and 115 degree angle, the prior one is a 95 degree angle but received request for one that puts the handles at more of an angle out into the room. Also 115 degree with 8in hole spacing for mounting into studs
Statistics
Likes
20
Downloads
0