Carbon Filter with FAN
Description
The STL is for a fan with 50 mm between holes. The filter used is Duratool as this https://www.farnell.com/datasheets/2702186.pdf Cut filter to match the slids in for the 4 filter sections. In Moai four 3 mm holes are drilled in the "middle plate widh hole for vat holder", it fits just to the right of the Z drive behind the vat. that matches the fan. Use 3 mm threaded rod. The fan shall at half te voltage as described - less noise and less wear on filters. Supplied is also the OpenScad definitions, sp it's possible to match other fan sizes or or other applications (soldering fume extractor)
Statistics
Likes
0
Downloads
0