MP Mini Delta Top Mount Spool Holder
Description
This allows you to mount the filament reel on the top of the printer for a MP mini delta. The top brackets (2 are needed) screw into the place where the stock handle was with the original screws. I used a 1/4" high speed drill bearing from the local hardware store to make sure the reel turns smoothly. The bearing goes into the bearing sleeve and that goes into the spool holder. The little peg on top of the top bracket rests in the center of the bearing. That is really all you need to make this "work". I used Hank-Cowdog's leg part again to make a filament guide so that the filament isn't going around a sharp corner, and it makes everything work very smoothly. A also used two of his original parts on the other two top corners just for looks. There were some other things uploaded like this but some couldn't even be printed on a mini delta, so I wanted to make my own. All of these can be printed on the tiny print bed, just in case this is your only printer.
Statistics
Likes
6
Downloads
0