Endmill-Holding Collet Wrench (DW660/ER11)
Description
I got tired of trying to hold the endmill into the collet on my DW660 while I tightened the chuck. This pushes the depth ring up into the holder holding the endmill in place. The balanced arms allow for sufficient torque without putting a lot of lateral forces on the chuck. The DW660 version is designed for a 16mm collet nut (flat to flat), which will also work for any 5/8" collet nut. The ER11 version is designed for a 17mm collet nut.
Statistics
Likes
7
Downloads
0