Spool Holders for Balco 3D Touch/Wanhao Plus/Maker select etc. (53/57mm width)
Description
UPDATE (17th feb 2019): Added a 53mm version as requested. This is a remix of the spool holder by Leon_123, I printed his version but it was too wide for my spool so one side kept falling in-between the bearings. The clearance on this one is 57mm and the spool still spins freely but keeps spinning straight. An awesome spool design and surprisingly the spool doesn't rock backwards and forwards when in use. Check your spool isn't wider than 57mm BEFORE printing! I'm happy to design different sizes if yours doesn't fit. You will need to print two axles (Filename- axle_608.STL) they are the same as Leons version so you can use them if you have printed them already. The axles accept 608 Bearings. I used 608 2RS bearings as they have a better seal against dust. This takes the standard plastic nut supplied for the original spool holder. The last photo is a comparison of the original on top of my remix.
Statistics
Likes
10
Downloads
0