SUPERMICRO CSE846 120MM CENTER FAN ARRAY (FOR SMALLER PRINT BEDS)
Description
These prints were designed to add to (3) 120mm fans to SUPERMICRO CSE846 SERVER in place of center fan array. This print requires no new holes to be made to server and reuses some existing holes. It also requires the relocation of case tamper sensor for lid into an existing hole. This will get you 98%+ of the way. Will require minor trimming as it's a WIP and is a snug fit. Case lid does fit but is snug. Needs to be printed in TPU and 3mm hardware (24) 3mm bolts (6) 3mm nuts (minimum - TPU holds 3mm bolts in place, (16) 3mm nuts optional) Should fit any 120mm case fans, I used noctua 120mm IPPC 3000rpm fans pwm. I relocated case tamper sensor about 2 inches forward and reused existing screw (only 1 screw reused, 1 left out) Air Shroud does wonders for cooling, but does not mount to this print. I just had it sit there and made huge difference in airflow. Definitely reccomend. Does not rattle File: CENTER-FAN-ARRAY-AIO v2.stl is an AIO print (not pieces) per request and is not required if printing the pieces. It also hasnt been tested for fitment so please let me know TPU is preferred as it is a tight squeeze and is only filament that is tested
Statistics
Likes
29
Downloads
0