ABL Mount for CR-10 Fang mod
Description
This is a remix of the abl mount by spotone for the ender3/ cr-10 to fit the cr-10 hanging fan mod for microswiss and e3d hotends. The mount is for an 18 mm proximity sensor. Links: spotone's mount: https://www.thingiverse.com/thing:3360306 Hanging fan mod: https://www.thingiverse.com/thing:2473423 I believe the offset is about 50mm in x direction and 20 mm in y. I have not tested it yet as I do not have my sensor but will update when available. Update: 1/31/19 I have tested the mount it works perfectly and if you use supports for the 18mm hole it should fit snug. Due to its obscure location being so far in the negative x direction the best bed probing grid I have found so far is start XY at 50 mm, end XY at 250 mm, and with 25 mm intervals.
Statistics
Likes
0
Downloads
0