Creality Ender-3 Control Box for BIQU/BigTreeTech SKR 1.1, 1.3, 1.4
Description
I liked the original control box this was remixed from, but the [BIQU/BigTreeTech SKR board](https://www.biqu.equipment/search?type=product&q=skr) requires a cutout for the microSD card, so I remixed this to add a cutout & recessed the the area around the card to make it easier to get to. You can use use the stock Ender lid or print the custom lid that houses two 40mm fans. According to the original designer, all wires should *just* reach, but there were many Ender-3s shipped with shorter-than-usual wires for the hotend, so you may have to extend yours. *Note: This will not work on the Ender-3 Pro due the the Y-axis redesign.* # Updates * **5/13/19**: New photos. * **4/8/19**: Added SKR 1.3 & 1.4-compatible case
Statistics
Likes
157
Downloads
0