Rain Gauge Counter
Description
Made a mecanically counting rain gauge with a housing. It´s collecting 1 mm of rain water until the tiping bucket tips and turns the ratchet wheel with numbers on it. Can measure up to 38mm of rain until it returns to 0 again. It´s 120 mm long and 57mm wide. Check out the rain gauge in action: https://youtu.be/Cj-3QvpIj8E To this rain gauge you will need to make 4 length of 1.75mm filament pins that you should melt on the end according to the picture with the following measurements: 2x 18mm 1x 13mm 1x 4mm Print without supports and larger pieces with 0.2 mm layer height and smaller pieces with 0.1. Recommended items needed: 1x 1.75mm filament 1x glue 1x lighter or similar (for melting ends of filament) Edit: unwohlpol fixed the normals for the bucket and the floor. Tip if you want updates or modifications
Statistics
Likes
78
Downloads
0