VonHaus Speaker Mount Wall Spacer
Description
With the way the VonHaus speaker mounts are originally designed, you can only pan or tilt a small speaker a few degrees before hitting the wall. This design spaces the bracket away from the wall and allows for a much greater angle of tilt and rotation so that you can better optimize your speaker placement and imaging. The two top holes on the design will take #12 2-1/4" wood screws. That length should get you through the drywall and into a stud. The countersink in the top hole will take a typical #12 washer. The bottom hole will thread in a #12 that is 1" or shorter. In this design, the speaker mount is upside down from what they show from the manufacturer, but I found that configuration works out better for mounting close to the ceiling.
Statistics
Likes
5
Downloads
0