Anycubic Mega I3 Mega Filament Spool Holder
Description
<b>please check out my Upgrade, Settings (Cura) Guide for the Anycubic: [Guide](https://cubprin.com/en/anycubic-i3-mega-mega-s-upgrade-guide/) schaut mal bei meiner Anleitung für jegliche Verbesserungen, Tipps und auch Einstellungen (Cura) vorbei: [Anleitung](https://cubprin.com/de/anycubic-i3-mega-mega-s-upgrade-anleitung/) </b> ----------------------------- This is a Filament Spool holder for the Anycubic I3 Mega. Its very strong and doesn´t bend in any direction. I added a cylinder so the spool runs smother. I also removed the filament guide, because i had some problems with it. Put the filamentholder on the right side of the printer. Clamp it at the bottom (below the 2 upper screws, like on the picture) Use the pipe form the original spool holder, and push it trough the filament holder. Put the little plug left, the big right. I have designed another filament Sensor holder, which works perfectly with this filament Spool holder: https://www.thingiverse.com/thing:3404001 This is a remix of the great Anycubic i3 Mega Spool Holder by philwild.
Statistics
Likes
137
Downloads
0