USB Buck Converter Case Remixed
Description
I remixed this to better fit my needs; the converts I purchased are Amazon ASIN B01HXU1C6U, listed as "HiLetgo 5pcs DC-DC Buck Step Down Module 6-24V 12V/24V to 5V 3A USB Charger Module Arduino". I made the following changes: * Tigher tolerance around the USB connector * Added an extra support beam near the rear of the board * Instead of having the wire slots in the center piece on the back go all the way to the bottom of the case, started them from about the height of the top of the board. * Tweaked the part that comes down from the lid to fit tighter against the USB connector, and to come down towards the board a bit further. * Tweaked screw holes to allow them to be tapped out for #6-32 screws, as I have a 6-32 tap and screws laying around. :) As a comment on the original noted, I needed to print this as 102% for the board to fit properly. I could've scaled up the source, but it's nice dealing with 1/10mm units, so I kept it as-is.
Statistics
Likes
45
Downloads
0