Graflex open viewfinder rear part
Description
One of my old Graflex press cameras was missing a part of the open viewfinder and I couldn´t find a spare part. Fortunately I had another one with the missing part intact which I could use to take measurements for making a replacement. It turned out quite nice and works perfectly. Print flat side down in 0.1mm resolution at slow speed. No support needed as the part already includes all the necessary supports which can then be cut open with a sharp knife before using the part. Note: The gaps where the lower section is inserted appear closed on the preview picture due to the support structures. The inner side surfaces next to the click openings should be slit open before inserting the lower section of the rear viewfinder part. The clicks for parallax correction on the viewfinder are as follows (from top to bottom): - infinity - 15 feet - 8 feet - 6 feet THIS ITEM HAS BEEN TESTED AND FOUND FULLY FUNCTIONAL. CREATING AND FINALIZING IT HAS TAKEN HOURS OF DESIGNING, MODIFICATIONS AND SEVERAL TEST PRINTS TO GET EVERYTHING RIGHT. PLEASE CONSIDER LEAVING A TIP VIA PAYPAL IF YOU FIND THIS ITEM USEFUL: e-mat-paypal(a)netti.fi
Statistics
Likes
2
Downloads
0