Mean Well LRS-350-24 PSU Cover and USB Port
Description
***PLEASE NOTE - This design DOES NOT use the mounting hole in the upright to mount the PSU. If you want to use the mounting hole, please see my other design https://www.thingiverse.com/thing:4724396. I was using the Ender 3 PSU cover by mfau until my stock power supply died. Since I am waiting for my replacement, (upgraded to a Mean Well LRS-350-24) I liked the holder by peed6687, but wanted the cord entering the rear, a buck converter inside, and a USB header from an old PC that I wanted to reuse. I can't say that it fits yet, but I will update/verify the fitment once my PSU comes in. This is just the bottom mount. UPDATE 13FEB2019 Version 2 with the following changes has been made: - Fixed buck converter mount - Modified rear power switch hole. v2 was blocking PSU from mounting holes. Printing it out now, will test again and update as required. If there's others that has any suggesstions/comments, please let me know, or modify/remix as needed. UPDATE 14FEB2019 Uploaded pictures of v2. Still need to tweak it a little bit more. Will upload the changes needed once completed and tested Update 15FEB2019 Uploaded version 3 with pictures. USB Connector is tight, but it fit. Made changes and uploaded version 4. Printing it right now and will probably be the final design. Will update this with the finished pictures once it is completed. Update 13MAY2019 Version 5 Uploaded. Filled up some seams that I had noticed, and did some changes to the inside to minimize support material. Will be printing it tonight and will upload pictures.
Statistics
Likes
102
Downloads
0