Wireflow ceiling pendant lamp
Description
This is a mostly printable ceiling pendant lamp inspired by the amazing Wireflow lamp by Arik Levy. To build one lamp you need: Printed parts 16x Corner_up 16x Corner_down 32x Cover_long 32x Cover_short 1x Base (Requires a large printer or split the model) 8x Pendant 8x Glass Hardware 16x M4 threaded rod 298 mm long 16x M4 threaded rod 87,5 mm long 8x Black 6mm cable 1950mm long 8x MR11 (GU4) lamp socket 16x Screw for lamp socket 3x10mm 8x MR11 (GU4) led spotlight 2W or less 1x 12V power supply Superglue To assemble glue a threaded rod between each corner piece and two covers on each threaded rod. Build each of the four layers on a flat surface to keep it straight. Glue the cable to the base and route through all the corners and into a pendant. Connect to the lamp socket at the bottom and to the 12V power supply at the top. The pendant glass should be printed in spiral mode and snapped into place. Hang the lamp and level the levels by sliding the cables in the corners. Secure with a tiny bit of glue. This lamp can be built in any size just adjust the length of the threaded rods, covers and cables.
Statistics
Likes
10
Downloads
0