CR10s Pro Filament Guide - Roller - Holder
Description
Remix of a few designs from others. This design takes care of the filament feed issues as well as what i believe to be a problem. The filament sensor is worthless except for 1 thing, to be used as an easy way to change colors in the middle of a print. Also gives you a better way to access the filament between the original filament sensor housing and the extruder filament feed hole. Great for some, good for others, may not so good for some.. Here are some photos of it installed on my machine. I have the filament sensor limit switch disconnected. U dont have to change anything, but disconnect and the system will disregard it completly.. if u want to use as a filament change switch. Just hook up like stock wiring and use tape to hold switch closed. Then when u want to change filament or color, take tape off and let switch activate, printer will go into filament change mode and u can then switch filament and then re-engage switch and tape over, printer will resume as was.. works great for multi color printing.. hope this helps.. and by the way u will need the roller and pin fro the other link i provided. Thanks.
Statistics
Likes
9
Downloads
0