Reach 3D Fan Shroud and ABL / Z-Min Sensor Bracket
Description
I had trouble with prints on my Reach 3D staying too hot and remelting on each pass. The stock fan was too far away. I put a 140mm fan nearby, but that didn't really fix the issue. I also have a Creality CR-10S, and that uses these very light-weight [40mm fans](https://www.amazon.com/gp/product/B07L2WT5QY/ref=ppx_yo_dt_b_asin_title_o04__o00_s00?ie=UTF8&psc=1). I thought that closer, more directed airflow would make a difference, and it really did. Finally, since this is the same fan from the CR-10/S, I used this fan shroud, modified with longer holes for the screws: https://www.thingiverse.com/thing:2303102 Note: I I'm using an E3D V6-compatible hotend on my Reach, not the stock V5 (I believe stock is V5). https://www.tinkercad.com/things/ju5Z03IiDMI
Statistics
Likes
0
Downloads
0