FPVLR CP Antenna Washer for Mavic & Spark
Description
This is a very simple "washer" designed to properly centre and hold the SMA connector into the Mavic Pro and Spark remote controller. When you want to upgrade your remote antennas, you have to install a standard connector, this is called a SMA connector. These are smaller than the holes that are in the remote for the factory antennas and as such it is left loose. I didn't just like the tension from the nut holding it down so designed this washer to both centre it, and provide a good surface for the lock washer and bolt to grip into. Many companies supply their own washers, but these tend to be just shop bought plastic spacers which aren't 100% the correct dimensions, these fix that. In my case, this were used with a FPVLR CP antenna onto a DJI Mavic Pro, but it should also fit a DJI Spark. If you have a FPVLR CP Antenna along with their amazing booster/amplifiers, check out my other thing called "FPVLR CP Antenna & Amplifier Mounting Bracket for Mavic & Spark" for a mounting bracket to hold it all onto the remote.
Statistics
Likes
0
Downloads
0