IUninker Pi Case Din Rail Mount
Description
Raspberry Pi Din rail mount for the iUniker Pi Case for 3B+ This mount was made for a PI being used in an industrial application. The cooling on this case is excellent. Mount is 6 parts (1 Wide Din Mount, 1 Narrow Din Mount, 2 Narrow Pi Mount, @ Wide Pi Mount). The standoffs are 2 different widths. Longer Screws will be needed to go though the standoffs. Then stand offs are screwed to din rail pieces. Pieces are a tight fit and might need a bit of sanding with 2000 grit sand paper. Pay attention to the widths as the one closest to the Micro-sd card slot is thicker as are the corresponding standoffs. Link to raspberry pi 3B+: https://www.microcenter.com/product/505661/raspberry-pi-3-model-b Link to iUniker Case: https://www.amazon.com/dp/B07T3Z4RH4/ref=cm_sw_em_r_mt_dp_U_9IrcEbH890PRY Longer Screws to go through standoffs into case: https://www.mcmaster.com/91292a835 Screws to mount stand off to Din rail mounts: https://www.mcmaster.com/95893a212 All parts printed with 30% infill. Recommend printing with PETG, But PLA should work.
Statistics
Likes
30
Downloads
0