Proton display dropthrough mount
Description
This is a mount I made to use the Proton display with dropthrough trucks. I designed this so it would not put the pressure of the hardware on the display case itself. Also to make it as low as possible you have to remove the uart plugs and solder the wires directly to the pcb. There is enough room in the case to route the wires under the pcb and out the front under the usb's. The case is two pieces. The mount piece the truck plate slides into and mounts to the board. The case piece holds the display and then slides onto the mount. I hope you enjoy. Ive put alot of work into this case and would love a small donation if you feel like giving one. I would also like to hear any feedback you have. ENJOY!!!
Statistics
Likes
8
Downloads
0