RC Wing Strut Supports
Description
This is my work-in-progress ( during the long winter months ) to my FT Simple Cub scratch built foam plane. As I get inspired, I design 3D parts to add further realism but not necessarily functionality to my little foamy. Each 3D printed wing strut support is hot glued to the fuse and wing after careful measuring. I use stake flags, which I had originally purchased from Home Depot to make control rods, for these struts. These measure 0.060" diameter and are cut down to 11.75" length. Check out other mods for this foamy - https://www.thingiverse.com/thing:3438626 and https://www.thingiverse.com/thing:2855083 and https://www.thingiverse.com/thing:3442863
Statistics
Likes
15
Downloads
0