Lego Storage Draw Dividers
Description
I made these for a parts drawer I bought from German retailer Hornbach. They are available through most of Europe with a EAN number of 4028354540184. Though it could be easily modified for another system. The exact drawer I have can be found [here](https://www.hornbach.se/shop/Sortimentskap-470x320x140-mm/962425/artikel-detaljer.html) Usually you print one, two or three `single` dividers per draw, if you want to sub-divide the drawers use either the `2x2` or `3x2` along with one or two `subdividers`. Print 8-10 `singles` for 8 hour print, or 4-5 `subdivider` settups (`2x2` + one `subdivider` or `3x2` + two `subdividers`). Subdividers have notches on each part that mate together so holding up the parts that dont have any pre-made slots in the drawer. Using a these combinations you can divide drawers up as follows. <pre><code> 2x3 + 2x subdividers |---|---|---| |---|---|---| |---|---|---| 2x2 + 1x subdivider |-----|-----| |-----|-----| |-----|-----| 1x single |--------|--------| | | | |--------|--------| 2x single |----|------|----| | | | | |----|------|----| 3x single |----|---|---|----| | | | | | |----|---|---|----| </code></pre>
Statistics
Likes
14
Downloads
0