Pogo-pin programming clip for Sonoff S31 modules
Description
This pogo-pin clip is designed to facilitate the reprogramming of the Sonoff S31 module without the need for soldering to the pads on the circuit board. The pogo-pins I used are 0.68 mm in diameter and 16 mm in length. The holes needed to be cleaned out with a 0.7 mm drill bit, and I further secured the pins with a drop of superglue. The Sonoff S31 smart switch is useful for DIY home automation, since it contains and ESP8266 chip and can be reprogrammed via the arduino IDE. Edit: I've added a new version (r4) which removes a couple of mm of material around the pogo pins. This should leave more of the pins exposed for making connections.
Statistics
Likes
40
Downloads
0