Z axis vslot trolley for Core XY
Description
Trolley Z for xy core, use the normal 25 mm vslot to slide on a 30x30 aluminum profile, the two trolleys are joined with a 20x20 section, has an automatic adjustment and recovery system with a normal bed spring . You will need them for both Z 4 vslot, 4 M5 30 mm screws, 4 M5 nuts, 4 m5 washers, 8 M4 screws with the corresponding hammer nuts for 20x20 profiles. Assembly: insert the nuts into the seat, insert the vslot in their seat with 2 M5 washers on the sides and tighten the screw until the lateral clearance is eliminated, insert the 20x20 section in the trolley with the shorter seat and tighten the screws, on the other part 20 mm for the 20x20 section in the center with a 5.5 mm bit, insert a 40 mm M5 screw with the spring, insert the carriage and insert it into the 30x30 frame, cut the 20x20 section to size so that it runs inside the trolley pushed by the spring, I will then tighten the 4 M4 screws to make the lock, the adjustment will automatically make the spring. ATTENTION NEVER PROVEN EXPERIMENTAL TRUCKS, I think that in any case it works perfectly, the two carts will then be joined by one or more 20x20 aluminum bars which will then support the bed. https://www.youtube.com/watch?v=MkgA7uHSsXY&t=11s
Statistics
Likes
11
Downloads
0