Nonna Nikki Anolini Press
Description
The design is for a a grid of NxM Anolini but it is recommend you print this is a 3 x 10 configuration to match the pasta width of most pasta makers dough extrusion. It was designed in OpenScad and is fully parametrized so you can adjust just about every dimension. Gift box for this and my other pasta presses: https://www.thingiverse.com/thing:3539286 See some of my other designs for ravioli, mini-ravioli, and empanadas: https://www.thingiverse.com/thing:3442017 https://www.thingiverse.com/thing:3515671 https://www.thingiverse.com/thing:3515645 Edit 3/24/2019: Added support for magnets to be glued into the press allowing you to chain together several of these to make a long press. This is handy if you have a dough machine (like a Kitchenaid) which makes long dough. Edited 3/6/2019: Added a 'traditional' version which doesn't use crimping to seal the pasta. Instead it uses a press fitting bevel that causes a slight rolling pressure. It seals the pasta without a visible seam. Edited 2/29/2019: Added a large version with ~15 Anolini. Also greatly optimized the design's printability. It no longer requires any supports.
Statistics
Likes
32
Downloads
0