The Dynabox V1 for The Dynavap M ~91mm

Description

Edit (3/9/19): New version added! Better fitting on the main lid with a new dedicated hatch for JUST the dynavap itself. No more risking dumping your material all over yourself! Just slide the top lid back a teensy bit and the small hatch will remove allowing you access to the dynavap alone. This is a carrying case and box for The Dynavap M. I specifically modeled this one after the pre-2018 version. As I'm not entirely aware of the measurements of every model of vaporizer that Dynavap sells, I just worked from my own measurements. The included cavity is 92mm in length. If you find your Dynavap vaporizer is shorter(or longer), inform me... and I'll do my best to modify this model to fit the specifications of each model submitted. Design: I didn't really like the stock ideas a lot of people were making online for this vaporizer and thought the dugout style just didn't really suit the utility of the M. Small holes for filling and no holes usually for dumping your material seemed more of a bother than not having a lighter hole. Personally, I can get a lighter anywhere, and would rather dedicate that extra space to making the vaporizer easier to fill and dump between sessions. It seems others have expressed their need of this as well and thus, the Dynabox was born. Notes: DON'T FLIP!!! I put a finger-groove-type-space at the cap-end of the dynavap cavity. Flipping would put your stored material in your lap, you sap. ...for now. There is a magnetized version coming soon, just doing some test prints to assure the location and depth of the magnets, along with what varieties more available and affordable for consumer purchase. This is a SERIOUS WIP. I've barely printed two of them but this model should work as-is. I'm printing it literally as I'm writing this. As soon as I'm sold on the tolerances between the lid and the box itself, I'll call it good... ...and start working on a V2 of course. I have lots of ideas already. Print settings: 0.2 is fine Use supports around the bars on the side of the box and on the inside of the lid. Print both the box and the lid flattest-face down. If your lid is too loose, tell me! If your lid is too tight, tell me! If your lid is just right... tell me! Future Implementations: - Sizes for all available Dynavap vaporizers - Compartment removal that allows JUST removing the vaporizer without revealing the material - Keyring version - Magnetized version - Tab-locking lid for the Non-Magnetized version - Different top plates (designs and art!)

Statistics

Category

Tags