Ribbon cable clip and Bltouch wires cr-10s pro
Description
Just a quick clip I made that I thought I should share. I wanted a way to guide the wiring for the bltouch along the ribbon cable on my CR-10S PRO. Printed 5 of these and spaced them about 15cm along the ribbon cable. Slide the ribbon cable in and squeeze. Clicks closed and holds firmly. Run the bltouch cables in the smaller outer holder. I used the scraper to slightly pry where the bltouch wires go. This may not be necessary but I found it easier to insert the wires. Also found it easier to install the bltouch wiring first then attach the clip to the ribbon cable.
Statistics
Likes
54
Downloads
0