X_Top_Stopper_Rods_RepRapGuru
Description
This is for the Reprapguru Prusa I3 V2, I customized this for T8 rods(Buy Amazon-Anet Lead Screw Rod and nut,345mm 8mm), Since it comes from factory with 5mm rods. Fits 8mm rods and its at 17mm apart. Simply Replace rods and the X_ Carriage from factory to the one from the link since the factory one only holds the 5mm rod , I used this for mine and printed the 17mm one. Smooth X-axis for Prusa i3 with Leadscrews---- https://www.thingiverse.com/thing:1103976. This is a mixture of Prusa i3 lasercut frame z axis leadscrew remix-https://www.thingiverse.com/thing:1559915 and Z Top Plates with leadscrew bearing- https://www.thingiverse.com/thing:1369178 Once you managed to do your changes to the printer don't forget to open the arduino software and run the configuration_h from your Marlin Firmware through sketch_feb Arduino. Find and replace values the printer so that it can calculate the right traveling for the new 8mm rods. //#define DISTINCT_E_FACTORS (default axis steps per units (steps/mm) ,#define DEFAULT_AXIS_STEPS_PER_UNITS { 80, 80, (ChangeValue here to 400 my personal setting), 90 }
Statistics
Likes
6
Downloads
0