Pool cue spring clamp
Description
Simple pool cue holder. Holds 4 cues. Attaches to a standard 2" spring clamp you can find just about anywhere (menards). Remove the plastic dipped sleeve from one side of the clamp, drill two holes through the clamp matching the spacing of the mounting holes in the print, and bolt to the clamp using two 4mm or #10 machine screws and nuts. Made just small enough to fit at an angle on my Maker Select printer. Clip the cue holder onto virtually any bar table edge. Stays secure and the deep notches for the cues will prevent them from getting knocked out by errant feet and falling to the floor. I use this every week for my pool league team. Considering modifying the design to a 2-piece holder to accommodate 6 cues. This is my first share. Let me know if you like it.
Statistics
Likes
7
Downloads
0