Creality CR10S-Pro filament guide
Description
I made my own filament guide, because other designs dont use a bearing or use a bearing but no 90° filament guide. For the upper part, you can stick in a small pice of a PTFE tube to lower the friction even more. I also glued the the bearing into the ring. What u need: 1x 608 Bearing 2x Washer (16x8.4x1.6) DIN125 1x Screw (M8x25) Info: The part which "clamps" on the housing of the existing filament run-out sensor is longer as on the pictures.
Statistics
Likes
80
Downloads
0