Lulzbot Mini 2 DropCam Low Camera Mount
Description
This was a remix from Raffen for his Lulzbot Camera. The mount worked great, but for the newer model, the build plate was a little different. I changed this in my design. I added printable screws and nuts in order to assemble the DropCam mount. The center peg was the only part that needed supports and I suggest making all of the bolts and nuts 100% infill at .18mm for best results. Sometimes the side bolt prints a little small on my printer, so make the side bolt 95% for a snug fit if this affects you. Light sanding is recommended and I had to drill out a notch in the mount because the end of a screw was preventing the whole rig from sliding into the corner.
Statistics
Likes
0
Downloads
0