RC Car based on DC Motor 550

Description

This RC Car is completely designed by me. # Print List ## RC Pad * 006-001_RC_Pad.stl ## Car * 2x 001-001_Frame.stl ABS recommended -- due to motor can be too hot for PLA * 2x 001-002 Battery Holder Support.stl * 1x 001-003 Cable Holder.stl (optional) * 1x 001-004 Underframe.stl * 1x 002-001 Secondary Gear.stl * 1x 002-002 Primary Gear.stl * 4x 003-001 Rim.stl * 4x 003-002 Tire.stl SEBS/Rubber material recommended * 1x 004-001 Steering Clamp.stl * 2x 004-002 Rod End.stl * 2x 004-003 Lower Arm.stl * 1+1 004-006 Steering Knuckle B.stl (_one original + one mirrored_) * 2x 004-104 Arm Bushing.stl * 1x 004-105 Normal enforcer.stl * 1x 005-001 Hood C.stl * 1x 005-002 Front Panel.stl * 1x 005-003 Front Bumper B.stl * 1x 005-004 Hood Holder.stl * 1x 005-005 Front Hood.stl Here is the list of electronic components you'll have to get: ## For the Car 1. **Arduino Nano** -- controller_ 2. **NRF24L01+** -- 2.4GHz radio module 3. **L298N** -- Dual full bridge dc-motor driver 4. **DSN-MINI-360** -- DC-DC Buck converter 5. **100uF 16V capacitor** -- _for radio module_ 6. 3pcs **2N3904** -- NPN bipolar junction transistor 7. 3pcs **100Ohms resistor** 8. **10Ohms resistor** 9. **4x18650 battery holder** 10. 4pcs **18650 battery** -- _i've took it from old laptop battery_ 11. **550 dc motor** -- _i've took it from the old ink-jet printer_ 12. **MG90S** -- servo for steering mechanics 13. 2pcs **3mm red LED** -- for the tail lights 14. 2pcs **3mm white LED** -- for the reverse lights 15. 2pcs **5mm red LED** -- for the brake lights 16. 2pcs **5050 white LED** -- for the headlights 17. 2pcs **30 Degree Angle Lens for 5050 LEDs** 18. **SS12D00G4** -- 2 Position 3 Pin Slide Switch Also, connectors, wires and 40x40mm breadboard ## For the RC Pad 1. **Arduino Nano** -- controller_ 2. **NRF24L01+** -- 2.4GHz radio module 3. **XY-016** -- DC-DC Boost converter 4. 2pcs **KY-023** -- XY-axis joystick module 5. **100uF 16V capacitor** -- _for radio module_ 6. **12x12 push button** 7. **SS12D00G4** -- 2 Position 3 Pin Slide Switch 8. **3mm green LED** -- 'ready' indicator 9. **1x18650 battery holder** 10. **18650 battery** Arduino firmware source can be taken from here: https://gitlab.com/bp3_niva/rc-car/tree/master/Firmware%20Sources Assembly instructions are not ready yet -- but i'll add it here once it get finished Pls feel free to ask if you have any questions

Statistics

Category

Tags