Buck Converter Housing for CR-10s Pro Fan Mods
Description
Designed a little housing to protect the buck converters needed when swapping out the parts cooling and extruder cooling fans on the CR-10s Pro for Noctua or other 12v fans. Mounts to the back of the extruder motor, where the black plate is, using any kind of double-sided adhesive tape. 2x12mm M3 screws will fasten the cover to the plate that the buck converters sit flush into. NOTE - to allow the converters to sit flush, solder the leads from above, not below, so that there is minimal solder or wire protruding from the bottom four corners of the converter. Leave me a comment if any other questions! Please, if you like the part, check out my design page on Instagram - #sandrodesigned and I'd greatly appreciate it if you used that hashtag when printing/using/sharing images of it on social media, etc! Thanks!
Statistics
Likes
33
Downloads
0