JGAurora A5 24v LED Tape Bed Light Bracket
Description
Just a simple LED tape bracket for the standard 10mm wide 24v led tape. This hooks under the lip at the front top of the frame and lets you slide in 200mm of LED tape. All you need to do then is attach some wire to your LED tape and connect it to one of the spare 24v output and ground terminals on the internal power supply, Voila, bed lighting. The piece has such a small footprint I had issues getting it to stay attached for the entire height, its highly recommended to print with a large raft, something such as a 10mm raft offset would be good to give the relatively small footprint some more bits on the build plate. I also highly recommend printing this in ABS, the 24v LED strips to generate a decent amount of heat which in my previous prints have over several months caused warping of the print. ABS would just make it more sturdy. It hasn't warped to the point they don't work anymore, just doesn't look as good as it should ;)
Statistics
Likes
11
Downloads
0