Karo - Ender 3 cooling fan duct
Description
Can't print a lattice cube? Ring coolers don't help much? Too lazy to print a Bullseye or Hero duct? -------- The Karo cooling fan duct was designed with the following considerations: - I want to actually be able to print a 3x3 lattice cube without the print being destroyed due to edges bending up - I really don't want to remount BL Touch because recalibrating that is just extra work - Try to make it crash into glass clips a bit less (more Y clearance) - Print in one piece - No supports Finished lattice photos are (relative to the cooler) from the side and from behind. Notes -------- **After installing, make sure the cooler fan does not collide with the duct.** If it does, take a knife to the pointy bit and cut off the leading edge a bit. (V1) The air wedge might be completely useless for all I know. Though I do know for a fact that some of the air is being blown away from the fan. I haven't done any fluid simulations of the sort. Reading a paper titled "An optimal design algorithm for centrifugal fans: Theoretical and experimental studies" would probably have helped if I thought to look it up ahead of time. It's named Karo because the skirt is sorta like a diamond shape, but naming it "Diamond" would probably be overestimating its performance. Lattice cube in photos: https://www.thingiverse.com/thing:1804350 (3x3x3 Lattice cube v4) Changelog -------- v1 - 2019-03-03 - Initial release v2 - 2019-04-20 - Adds notch for improved ambient cooling, changes volute tongue angle to 90° (appears to improve air flow but increases noise slightly)
Statistics
Likes
77
Downloads
0